Overlapping function?

This forum is for general discussion about Aspire
Post Reply
angelosart
Vectric Apprentice
Posts: 53
Joined: Mon Jan 07, 2013 7:11 pm
Model of CNC Machine: Shopbot Buddy32

Overlapping function?

Post by angelosart »

Hi

I only did this once before...I have a project that is too large (width) for my cnc. Its been a long time but I believe the last time I used an overlapping function in Aspire to create two overlapping toolpaths. I cut the first half, then slid the wood down and cut the second half and as a result it overlapped the two toolpaths to minimize a visible seem between the two cuts. Am I wrong, I can't find the function?

Angelo

4DThinker
Vectric Wizard
Posts: 1701
Joined: Sun Sep 23, 2012 12:14 pm
Model of CNC Machine: CNC Shark Pro, Probotix Meteor 25" x 50"

Re: Overlapping function?

Post by 4DThinker »

Tiling. On the tool path side menu. Bottom row, center icon.

Post Reply