We are using the fast tool change on our Camaster. We just spoke with Vectric support and they verified our g-code is correct, so it looks like the next step is to contact Camaster.
firstname.lastname@example.org wrote:It has been suggested in another forum that Aspire Pocket Toolpath with large area clearing tool is only for flat cutters and cannot work with a ballnose. Is this true?
Mobius wrote:It is hard to judge scale from the picture, but where does the center line of the ballnose bit end up with regards to the lip you see in the picture? It should be dead center on the edge of the end mill cut, otherwise the cut will start to move up the radius of the ballnose and create a lip.
Something like the picture? Have you tried offsetting the cut inwards? Or is the opposite true? Is the center line of the cut too far inboard?
Users browsing this forum: No registered users and 4 guests