If I don't misunderstand your question, I would draw the negative space (i.e., draw the rectangles 3" wide each that would be outside the panels) at each end and in between the panels and then use the space selection tool within alignment to set the "interior" ones. I use layers and would place the negative space rectangles on a separate layer. Use the horizontal measuring tool and create the panels as rectangles, or dynamically draw the panels (rectangles) to fit. Then I'd place the actual panels within the evenly spaced "openings" between, using the align to selection tool, selecting each "panel" in turn and selecting the appropriate "negative space" rectangle.
- Negative Space.crv
- (62.5 KiB) Downloaded 100 times