Return to point after accidentally hitting e-srop
-
- Posts: 10
- Joined: Thu Dec 03, 2015 4:34 pm
- Model of CNC Machine: Shark HD 3
Return to point after accidentally hitting e-srop
I'm running my shark HD3 and accidentally hit e-stop. Please don't ask how, just did. How do I return to the point where the machine was when I hit the e-stop? Thanks, James
Re: Return to point after accidentally hitting e-srop
The machine should stop when you hit the Estop. Are you sure you have it wired correctly?
- FixitMike
- Vectric Wizard
- Posts: 2177
- Joined: Sun Apr 17, 2011 5:21 am
- Model of CNC Machine: Shark Pro Plus (retired)
- Location: Burien, WA USA
Re: Return to point after accidentally hitting e-srop
Which E-stop did you hit? Did you click on the one one the screen or the push the button on the controller? If it was the button on the controller, it cut power to the controller and you are out of luck. I've not used the E-stop on the screen.
I don't believe there is a way to return to where you were with the Shark controller. However, if you know the line number it stopped on, you can edit the G-code to remove the moves before it, rezero, and then run the new program. Probably easiest to add the wood to the fireplace pile and start over.
I don't believe there is a way to return to where you were with the Shark controller. However, if you know the line number it stopped on, you can edit the G-code to remove the moves before it, rezero, and then run the new program. Probably easiest to add the wood to the fireplace pile and start over.
Good judgement comes from experience.
Experience comes from bad judgement.
Experience comes from bad judgement.