I am within 8 thousands of an inch and am getting some more shim stock. I am not sure how close I can get but for a DIY project, I think it is coming good.
I wouldn't get too concerned with using a lot of shim stock since the size of cold rolled steel you are using will have a minimum of .005" to a maximum of .012" variance in thickness and it's doubtful you get it all out. I'd be just as concerned with leveling it end to end, side to side and corner to corner. Also making sure the flats on both sides remain flat with each other.
Users browsing this forum: No registered users and 0 guests