Importing Own 3D Model

Discussions and examples relating to the Design & Carve series for Aspire

Moderator: Todd Bailey

Importing Own 3D Model

Postby mzongkers » Thu Dec 17, 2015 6:47 pm

I am making religious carvings that are about the size of a piece of paper. The model itself needs to be 3/4 inch thick and will be pocketed around it. I have tried building components (arms, legs, etc.) from a picture I imported but have not been able to get the detail and quality needed. I have also created my own 3d model of Jesus out of a action figure and I did that through other software. I am able to get a good amount of detail in my 3d model I created but when I transfer it into Aspire I am losing a lot of the finer details I need. I have been saving it as a OBJ or STL file. I was wondering if anyone has used an external 3d modeling software and transfer it into Aspire? Any suggestions on how not to lose the detail?
Vectric Apprentice
Posts: 11
Joined: Mon Dec 14, 2015 7:53 pm
Model of CNC Machine: laguna

Re: Importing Own 3D Model

Postby mezalick » Thu Dec 17, 2015 8:23 pm

What modeling resolution do you have your job set to.
Standard is fair but you may need to go to maximum to get the results you want.
Take a look at page 6 of the Aspire Manual..

Michael Mezalick
User avatar
Vectric Wizard
Posts: 2506
Joined: Mon Nov 03, 2008 9:07 am
Location: Philadelphia, PA USA
Model of CNC Machine: Camaster Cobra

Return to Design & Carve - Aspire

Who is online

Users browsing this forum: Google [Bot] and 1 guest