15" Clock Photo Vcarved
-
- Vectric Craftsman
- Posts: 233
- Joined: Wed Jul 10, 2013 3:43 am
- Model of CNC Machine: Home made
- Location: Canada
Re: 15" Clock Photo Vcarved
Oh OK thanks. I was just picturing it rong probably. I'll have a go at it and see how it turns out. Thanks.
-
- Vectric Craftsman
- Posts: 201
- Joined: Fri Oct 31, 2014 8:14 am
- Model of CNC Machine: TS1325
Re: 15" Clock Photo Vcarved
Hi Glenn,
That is a lovely wonderful project, thanks for sharing.
Kind regards
Jane
That is a lovely wonderful project, thanks for sharing.
Kind regards
Jane
-
- Vectric Craftsman
- Posts: 129
- Joined: Wed Mar 30, 2011 5:55 pm
- Model of CNC Machine: RF31, 4X8 Router both CNC
Re: 15" Clock Photo Vcarved
Super nice
Have you an others you can share with us?
Ray
Have you an others you can share with us?
Ray
-
- Vectric Craftsman
- Posts: 130
- Joined: Thu Oct 06, 2011 11:40 am
- Model of CNC Machine: home built and modified Vytek rebel
- Location: Troutman, NC
Re: 15" Clock Photo Vcarved
Hi
I like to thank everyone for all the nice complements. And I would also like to thank everyone that has posted their own journeys so I and others could learn from them. To date this is the nicest photo carve I have done but I do have several others post in both the general and gallery section with some info on how I did them.
Thanks
Glenn
I like to thank everyone for all the nice complements. And I would also like to thank everyone that has posted their own journeys so I and others could learn from them. To date this is the nicest photo carve I have done but I do have several others post in both the general and gallery section with some info on how I did them.
Thanks
Glenn
-
- Vectric Craftsman
- Posts: 233
- Joined: Wed Jul 10, 2013 3:43 am
- Model of CNC Machine: Home made
- Location: Canada
Re: 15" Clock Photo Vcarved
Here is my first try. Just on a scrap piece I had in the garage. Next time I will seal before carving like you said you did, but I wanted to do it and see what happened. I think it turned out OK.
-
- Vectric Craftsman
- Posts: 130
- Joined: Thu Oct 06, 2011 11:40 am
- Model of CNC Machine: home built and modified Vytek rebel
- Location: Troutman, NC
Re: 15" Clock Photo Vcarved
I think it came out great especially if you were trying to achieve an old antique look.