Hot to, CNC miter

This section is for useful tips and tricks for Aspire

Hot to, CNC miter

Postby robert_woodguy » Sat Feb 14, 2015 5:03 am

Hi guys,
Since a photo's worth many words, from this :

CNC miter-Woodworking-2.jpg


Anyone has an idea what is the toolpath strategy, and how can it be done, what "special" tooling is needed to get such "crisp" miter lookalike corners ?
I'm.....lost :?
Thanks, Robert.
robert_woodguy
Vectric Apprentice
 
Posts: 13
Joined: Sat Sep 14, 2013 1:11 pm
Model of CNC Machine: MechMete home build

Re: Hot to, CNC miter

Postby zeeway » Sat Feb 14, 2015 11:31 am

A vee tool can do sharp internal miter corners such as in your example. The rosette design may have been done by a small diameter ball nose tool...perhaps a 1/8 tapered ball nose cutter. You can also use a sharp vee bit with a tiny nose radius to cut such designs, but it would take a very long time.

Angie
User avatar
zeeway
Vectric Wizard
 
Posts: 3157
Joined: Thu Feb 11, 2010 9:24 pm
Location: SC, USA
Model of CNC Machine: Self-built

Re: Hot to, CNC miter

Postby Leo » Sat Feb 14, 2015 3:15 pm

I have not yet explored this - but - I think the "rest" machining strategy would be a good fit to do a project like this. This is where you would use all the normal tooling, like a 1/4 ball nose to rough 3D, and a 1/4 flat end mill to do some pocketing, then a 1/8 taper ball nose for the rosette and possible the frame profile. The rest machining would get into the corners and tiny details with a v-bit - maybe 60 degree.

It's a nicely challenging project.
Imagine the Possibilities of a Creative mind

www.leosworkshop.com
User avatar
Leo
Vectric Wizard
 
Posts: 2950
Joined: Sat Jul 14, 2007 3:02 am
Location: East Freetown, Ma.
Model of CNC Machine: 1300 x 1300 x 254

Re: Hot to, CNC miter

Postby Mike-S » Sat Feb 14, 2015 6:18 pm

This is a quick try with a 1/16hth BN.
Attachments
doorcarve.jpg
User avatar
Mike-S
Vectric Wizard
 
Posts: 1093
Joined: Mon Jun 13, 2011 6:45 am
Location: Hayesville, NC
Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)

Re: Hot to, CNC miter

Postby IloveVectric » Wed Feb 25, 2015 6:52 am

I used one of those ball nose cutters that tapers down to 1/32 at the tip.
Run a roughing tool path, then a finishing with the 1/32 tapered ball nose and a normal person will never guess it was made on cnc.
IloveVectric
Vectric Apprentice
 
Posts: 11
Joined: Thu Nov 03, 2011 4:05 pm
Model of CNC Machine: Mach3 compatible


Return to Aspire - Tips and Tricks

Who is online

Users browsing this forum: No registered users and 4 guests