Modeling Cuts bleeding to rest of material

This section is for useful tips and tricks for Aspire

Modeling Cuts bleeding to rest of material

Postby MisterBob » Fri Dec 19, 2014 4:37 pm

When I do a two rail sweep, the cutting path 'bleeds' onto the waste area of the material. This makes for long tooling calculations, excess cutting paths and impossible clamping issues for two sided carving. My work around is to offset a smaller area for carving so the waste area is ignored. This makes 2 sided referencing a bit more complex and it still sets us passes over area I don't want to process on work that is not rectangular.

Any help on this would be greatly appreciated.

Bob
MisterBob
 
Posts: 6
Joined: Fri Aug 08, 2014 2:10 am
Model of CNC Machine: CRP PRO4848

Re: Modeling Cuts bleeding to rest of material

Postby Adrian » Fri Dec 19, 2014 5:31 pm

Have you used a zero plane in your model and set the offset in the actual roughing and finishing tool paths?
User avatar
Adrian
Vectric Archimage
 
Posts: 9600
Joined: Thu Nov 23, 2006 2:19 pm
Location: Surrey, UK
Model of CNC Machine: ShopBot PRS Alpha 96x48

Re: Modeling Cuts bleeding to rest of material

Postby dealguy11 » Fri Dec 19, 2014 5:39 pm

Did you set a boundary vector just around the carved area and select it before doing the calculations? Your carving should not "bleed" into areas you don't want it to as long as you set the boundary vector properly.
Steve Godding
D&S Artistic Woodworking http://www.dsartisticwood.com
User avatar
dealguy11
Vectric Wizard
 
Posts: 1444
Joined: Tue Sep 22, 2009 9:52 pm
Location: Henryville, PA
Model of CNC Machine: Anderson Selexx 510

Re: Modeling Cuts bleeding to rest of material

Postby MisterBob » Fri Dec 19, 2014 7:57 pm

I will try this process this evening, Thank you for your suggestions!

Bob
MisterBob
 
Posts: 6
Joined: Fri Aug 08, 2014 2:10 am
Model of CNC Machine: CRP PRO4848

Re: Modeling Cuts bleeding to rest of material

Postby MisterBob » Sat Dec 20, 2014 1:18 am

Gentlemen, I thank you!

That has resolved my issue! I am back to making sawdust!

Bob
MisterBob
 
Posts: 6
Joined: Fri Aug 08, 2014 2:10 am
Model of CNC Machine: CRP PRO4848


Return to Aspire - Tips and Tricks

Who is online

Users browsing this forum: No registered users and 5 guests