martin54 wrote:Mach3 doesn't play well with others so having nothing else on there is the way to go, as has been suggested have a look at any power save options, screen savers etc etc. I would set the screen saver to none, set the display & HDD never to turn off & if you use a USB device to transfer your gcode then unplug it before you hit cycle start.
Think I have the security centre switched off but certainly have the automatic updates disabled.
Does the computer have a separate graphics card or does it use onboard graphics? Read some where on their support forum that mach3 prefers a separate graphics card but mine seems to run ok from the onboard graphics chip.
Users browsing this forum: No registered users and 1 guest