I recently sent the following e-mail to NWA support:
I seem to have developed a short circuit in the wire of my touch plate. When I try to test the plate it shows no response. If I wiggle the small wire leading to the magnet I will get occasional “successful” contact. If I release the small wire I lose contact. The problem appears to be at the point were both wires enter the boot that attaches to the plate. Can I get a replacement wire? If so, what is the process and the cost.
I didn't here anything right away (sent on a Saturday morning) and was a bit disappointed. However, on Tuesday morning I received a new wire in the mail At no charge!
This is what I call real customer service. Kudos to the NWA support team!!
NWA Support Team
- Ms Wolffie
- Vectric Wizard
- Posts: 2695
- Joined: Sat Mar 31, 2012 10:41 pm
- Model of CNC Machine: Blue Elephant 1325, Shark HD Pro
- Location: Tully Heads, Wet Tropics, Queensland, Australia
Re: NWA Support Team
Lucky you.
I am still waiting on a reply to an email I sent 3 months ago.
Cheers
Wolffie
I am still waiting on a reply to an email I sent 3 months ago.
Cheers
Wolffie
Cheers
Wolffie
Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6
Wolffie
Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6
- martin54
- Vectric Archimage
- Posts: 7355
- Joined: Fri Nov 09, 2012 2:12 pm
- Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
- Location: Kirkcaldy, Scotland
Re: NWA Support Team
This is the sort of info it's good to know, you never really know how good a company are until you have a problem. It's how they deal with them that make a good Conpany as far as I am concerned.
Thanks for taking the time to post.
Thanks for taking the time to post.