I just purchased a V90 by probitix to cut lithophanes on with photovcarve..
Does anyone have the correct feed and speed rates to cut them??? I keep loosing Z height when I cut them... I slowed X and Y and Z down... But having trouble with Z...
X and Y seem to be fine..
Probotix V90 and Photvcarve
-
robbie9gallagan
- Posts: 14
- Joined: Wed Aug 31, 2011 1:35 pm
- Model of CNC Machine: Anderson Stratos Pro
-
ozymax
- Vectric Craftsman
- Posts: 245
- Joined: Thu Jan 02, 2014 4:34 am
- Model of CNC Machine: Home built cnc router using Masso G3.
Re: Probotix V90 and Photvcarve
I have read about a similar problem to this on another forum, where the Z was loosing or gaining height and the fix was to run the stepper drives in at least 1/8 micro stepping.
Try that.
Try that.
-
martin54
- Vectric Archimage
- Posts: 7352
- Joined: Fri Nov 09, 2012 2:12 pm
- Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
- Location: Kirkcaldy, Scotland
Re: Probotix V90 and Photvcarve
What control software are you using? Are you only losing steps when cutting lithophanes or does it happen with other machining as well.
-
robbie9gallagan
- Posts: 14
- Joined: Wed Aug 31, 2011 1:35 pm
- Model of CNC Machine: Anderson Stratos Pro
Re: Probotix V90 and Photvcarve
usb controller by planet cnc..
only on lithophanes..
only on lithophanes..