Hello,
my first problem. I have purchased the animal collection and most cut very nicely. However the deer does not cut one of the rear legs. I've tried this a few times but it misses the same spot evrytime. I've tried to cut in a different location on the machine. same problem. Any ideas?
Bruce
PS I don't know how to attach a picture. it says too big a file.
Problem with deer machining
Moderator: Todd Bailey
-
- Vectric Apprentice
- Posts: 55
- Joined: Fri Oct 12, 2007 12:30 am
- Location: DE
- Contact:
Re: Problem with deer machining
The Deer cuts fine, I have cut many of them. I think you have to increase the z depth when you setup the model for the toolpaths in cut3d which will bring out the detail better.
- RoutnAbout
- Vectric Wizard
- Posts: 2088
- Joined: Mon Sep 19, 2005 11:09 pm
- Model of CNC Machine: 24x18 Desktop
- Location: North Manchester, Indiana
Re: Problem with deer machining
Hello B Griffith,B Griffith wrote:Hello,
my first problem. I have purchased the animal collection and most cut very nicely. However the deer does not cut one of the rear legs. I've tried this a few times but it misses the same spot evrytime. I've tried to cut in a different location on the machine. same problem. Any ideas?
Bruce
PS I don't know how to attach a picture. it says too big a file.
I'm curious at how it looks in the preview.
Does the problem show up in the preview?
There may be a problem with the file its self.
You might want to email James at
jab(at)carve3d(dot)com
with this issue. Send a photo of the problem and I'm sure he'll reply without much delay.
-
- Vectric Apprentice
- Posts: 55
- Joined: Fri Oct 12, 2007 12:30 am
- Location: DE
- Contact:
deer problem
Ok I'll do both suggestions. Thanks
Bruce
Bruce