need some help

This forum is for general discussion about Aspire
Post Reply
tfewox
Posts: 2
Joined: Sat Aug 18, 2018 1:59 am
Model of CNC Machine: shark cnc hd4

need some help

Post by tfewox »

this is the tool I have trying to figure out the right setting the setting came from there web site but it doesn't look right to me using aspire 9.5 thank you for your help
Attachments
Capture tool.PNG

ger21
Vectric Wizard
Posts: 1592
Joined: Sun Sep 16, 2007 2:59 pm
Model of CNC Machine: Custom DIY
Location: Lake St Clair, MI, USA
Contact:

Re: need some help

Post by ger21 »

I answered your post on CNC Zone yesterday.
Diameter = 0.25
Tip Radius = 0.0625
Gerry - http://www.thecncwoodworker.com

tfewox
Posts: 2
Joined: Sat Aug 18, 2018 1:59 am
Model of CNC Machine: shark cnc hd4

Re: need some help

Post by tfewox »

ok thank you didn't see it should the step over and the and clearance pass be the same about the same 5% 10%

ger21
Vectric Wizard
Posts: 1592
Joined: Sun Sep 16, 2007 2:59 pm
Model of CNC Machine: Custom DIY
Location: Lake St Clair, MI, USA
Contact:

Re: need some help

Post by ger21 »

Most people use 6%-10%, depending on the project, how fast you want it to cut, and what you want the finished look to look like. It's a matter of personal preference.
But you'll definitely want it higher than 1.2%.
The Clearance setting is fine.
Gerry - http://www.thecncwoodworker.com

Post Reply