Moderator: Todd Bailey
Chilidawg wrote:I do a lot of precise laser engraving in between a few carves.
my laser movements on this machine have never had a problem.
What I meant by my statement was that I tried to carve this once and it went wrong.
I did 6 or 8 other projects on the same machine without incident.
Then went back to try the carve again and it did the same thing.
the final cut pushed to the left on both attempts.
ezurick wrote:I am no expert in 3D carving, and in fact I just started getting into it. But for the life of me, I can't tell what that picture is... is it s shirt with outlines of underwear at the bottem? lol. Sorry, but it is really hard to tell what is right and what is wrong. Also what spindle do you have on your xcarve machine and what speed settings? which tool are you using for the finish. As others have said, if you are losing steps, then possibly you need to re-think your speed settings on the finish.
Users browsing this forum: No registered users and 7 guests