Photo V feed and speed

This forum is for general discussion about PhotoVCarve.

Photo V feed and speed

Postby zbaldridge » Sat Dec 27, 2008 12:09 am

I've searched around for some good starter feed and speeds for carving images in hardwood with not a lot of luck. I'm using a 60degree 1/4 carbide v-bit, and am using the default speeds in PVC (100" permin). I know there is some tweeking to be done, but are there any updated figures anyones using? I'm running 18k rpm on a spindle. Quality looks good, but being new to shopbot and wood milling, dont know if things can run faster carving out such little material. Thanks
Posts: 2
Joined: Thu Dec 11, 2008 11:54 pm

Return to PhotoVCarve - General

Who is online

Users browsing this forum: No registered users and 7 guests