I am attempting to use PhotoVCarve (sometimes I get good results and sometimes not so good
With all carvings though, I am getting a deeper cut on the upper left side of the carving. I have set the carving depth at 0.05 inches. It starts off at this depth but as it continues along it gradually digs deeper into the wood. The final depth on the far upper left can be just shy of 1/4 inch deep.
I have surfaced the board prior to cutting.
I zero the XYZ in the centre.
I am saving the file as a .PVC and then importing the file in VCarve Pro 8.
The preview image does not show this increased depth.