This forum is for general discussion about PhotoVCarve.
Got into my first project and realized I don’t have many bits since I just got a starter set with my CNC. My best result was with a 30* 0.25 vbit but I feel like I should be able to get better definition. What are some of your favorite bits to use with PVC before I run off to Amazon and fill my cart with useless bits?
- Posts: 12
- Joined: Wed Apr 11, 2018 3:05 pm
- Model of CNC Machine: Axiom AR8 Pro+
Hi: For lithophanes I use a tapered .0625 ball nose on pictures that don't have too much intricate detail. For highly detailed pictures I have gone down as small as .020 ball nose. The smaller the bit, the more time it takes.
- Vectric Wizard
- Posts: 385
- Joined: Wed Apr 01, 2009 12:15 am
- Location: Dunnellon, Florida
Return to PhotoVCarve - General
Who is online
Users browsing this forum: No registered users and 4 guests