Post Processor for Shapeoko xl

This forum is for general discussion about PhotoVCarve.
Post Reply
Bbbert
Posts: 5
Joined: Mon Jul 03, 2017 3:18 am
Model of CNC Machine: Shapeoko 3 xl

Post Processor for Shapeoko xl

Post by Bbbert »

Ok so I am new to this and trying to use Photocarve 9.0. I have a Shapeoko xl machine and can not find a post processor that will work. Support sent me a Shapeoko file to install in the pp folder in photocarve.....that done and in file manager the file shows up in the pp file...when I try to use the program the file does not show up.....I am using Windows 10. Any ideas to help. Thanks

Bonch
Vectric Apprentice
Posts: 99
Joined: Tue May 10, 2016 2:31 pm
Model of CNC Machine: Shapeoko

Re: Post Processor for Shapeoko xl

Post by Bonch »

My advice is to just use the GRBL post processor. It works great. The Shapeoko ones I have tried have sent my machine into orbit.

Bbbert
Posts: 5
Joined: Mon Jul 03, 2017 3:18 am
Model of CNC Machine: Shapeoko 3 xl

Re: Post Processor for Shapeoko xl

Post by Bbbert »

I will try that one,,thanks

Post Reply