Post Processor for Shapeoko xl

This forum is for general discussion about PhotoVCarve.

Post Processor for Shapeoko xl

Postby Bbbert » Sat Jul 29, 2017 10:52 pm

Ok so I am new to this and trying to use Photocarve 9.0. I have a Shapeoko xl machine and can not find a post processor that will work. Support sent me a Shapeoko file to install in the pp folder in photocarve.....that done and in file manager the file shows up in the pp file...when I try to use the program the file does not show up.....I am using Windows 10. Any ideas to help. Thanks
Bbbert
Vectric Apprentice
 
Posts: 5
Joined: Mon Jul 03, 2017 3:18 am
Model of CNC Machine: Shapeoko 3 xl

Re: Post Processor for Shapeoko xl

Postby Bonch » Sun Jul 30, 2017 12:04 am

My advice is to just use the GRBL post processor. It works great. The Shapeoko ones I have tried have sent my machine into orbit.
Bonch
Vectric Apprentice
 
Posts: 65
Joined: Tue May 10, 2016 2:31 pm
Model of CNC Machine: Shapeoko

Re: Post Processor for Shapeoko xl

Postby Bbbert » Sun Jul 30, 2017 12:38 am

I will try that one,,thanks
Bbbert
Vectric Apprentice
 
Posts: 5
Joined: Mon Jul 03, 2017 3:18 am
Model of CNC Machine: Shapeoko 3 xl


Return to PhotoVCarve - General

Who is online

Users browsing this forum: No registered users and 4 guests