Photocarve

This forum is for general discussion about PhotoVCarve.
Post Reply
flyingfischead
Posts: 1
Joined: Tue Jun 13, 2017 8:16 pm
Model of CNC Machine: Homebuilt

Photocarve

Post by flyingfischead »

I hope I'm on the right group. Excuse me if not. I have read tricks for using photocarve to produce a better product then I have been able to get. Do these tricks apply to Vcarve desktop or Pro and above? So far it has been less than expected. Any insight or instruction appreciated.

User avatar
Adrian
Vectric Archimage
Posts: 14503
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: Photocarve

Post by Adrian »

PhotoVCarve is a very different product to VCarve.

If you could say what areas you're having problems with I have no doubt you will get lots of help.

Post Reply