This forum is for general discussion about PhotoVCarve.
I hope I'm on the right group. Excuse me if not. I have read tricks for using photocarve to produce a better product then I have been able to get. Do these tricks apply to Vcarve desktop or Pro and above? So far it has been less than expected. Any insight or instruction appreciated.
- Posts: 1
- Joined: Tue Jun 13, 2017 8:16 pm
- Model of CNC Machine: Homebuilt
PhotoVCarve is a very different product to VCarve.
If you could say what areas you're having problems with I have no doubt you will get lots of help.
- Vectric Archimage
- Posts: 7805
- Joined: Thu Nov 23, 2006 2:19 pm
- Location: Surrey, UK
- Model of CNC Machine: ShopBot PRS Alpha 96x48
Return to PhotoVCarve - General
Who is online
Users browsing this forum: No registered users and 6 guests