kristenanne77 wrote:I was going to try and import the PhotoVCarve file into VCarve desktop 8.5 but I do not see an option for tapered ballnose in the VCarve program.
kristenanne77 wrote:Unfortunately, when I imported the PhotoVCarve toolpath file into VCarve, I was unable to change the bit size that I originally used with PhotoVcarve to the new tapered ballnose bit entry in VCarve.
kristenanne77 wrote:In PhotoVCarve, I will try creating a new "engraving bit" with a diameter of .25 inch, side angle 0f 6.2 deg, and a flat diameter of 1/32 (.03125). That should be close.
Users browsing this forum: No registered users and 4 guests