New to PhotoVCarve and seem to be lost

Post by **zehrah** » Tue Jun 28, 2016 7:48 pm

Hello;
I have followed all the tutorials, read all the literature I can find. When using PhotoVCarve, I do all the steps in the tutorials. All looks good. Save and open in control panel 2. And will only carve a .25 square. It seems like I have clicked somewhere I wasn't supposed to, surely in need of some experienced help.
Any help will be greatly appreciated.

Zehrah

Post by **Rcnewcomb** » Tue Jun 28, 2016 7:57 pm

Might be a mismatch between millimeters and inches or the wrong post processor. Can you post your PhotoVcarve file?

Post by **zehrah** » Tue Jun 28, 2016 8:52 pm

Rcnewcomb;
I have checked, double checked, triple....you get the picture , I hope it is something minor, flip of a switch...or something. But I feel very humbled by this challenge...lol.

Post by **zehrah** » Tue Jun 28, 2016 9:12 pm

another pic

Post by **zehrah** » Tue Jun 28, 2016 9:16 pm

another...

Post by **Rcnewcomb** » Tue Jun 28, 2016 9:38 pm

I'm not sure if that is the correct post-processor for the Shark. I'll let Shark owners chime in.

Post by **tonydude919** » Wed Jun 29, 2016 12:19 am

You have the wrong post processor use this instead for your machine. This is from next wave automation website. Must use this one only.

Post by **tonydude919** » Wed Jun 29, 2016 12:20 am

also for metric

Post by **tonydude919** » Wed Jun 29, 2016 12:22 am

http://shop.nextwaveautomation.com/shop ... x?recid=26

Vectric Customer

New to PhotoVCarve and seem to be lost

New to PhotoVCarve and seem to be lost

Re: New to PhotoVCarve and seem to be lost

Re: New to PhotoVCarve and seem to be lost

Re: New to PhotoVCarve and seem to be lost

Re: New to PhotoVCarve and seem to be lost

Re: New to PhotoVCarve and seem to be lost

Re: New to PhotoVCarve and seem to be lost

Re: New to PhotoVCarve and seem to be lost

Re: New to PhotoVCarve and seem to be lost