pocket tool and z axis

This forum is for general discussion about PhotoVCarve.
Post Reply
snidley7
Posts: 5
Joined: Fri Jun 29, 2012 1:24 pm
Model of CNC Machine: 3 axis router

pocket tool and z axis

Post by snidley7 »

When using the pocket tool and making multiple passes, my cutter tool goes up to z clearance height after every single pass. Is there a way to prevent this from happening? The machine wastes a lot of time moving the z up and down when it is not necessary.

I am using V-Carve 6.5, is it possible that this issue was fixed on one of the newer versions?

Thanks.

snidley7
Posts: 5
Joined: Fri Jun 29, 2012 1:24 pm
Model of CNC Machine: 3 axis router

Re: pocket tool and z axis

Post by snidley7 »

Sorry, wrong forum category, I will resubmit.

Post Reply