Router not mouving!

This forum is for general discussion about PhotoVCarve.
Post Reply
franazzo
Posts: 21
Joined: Sat Jul 11, 2015 2:15 am
Model of CNC Machine: Shapeoko 3

Router not mouving!

Post by franazzo »

Hi
I am wondering if any of you can help me! In Vectric photo V carve - I select my photo and go thru all the instructions and then save the program in inches. I also save the G code.
I am using the universal G-code sender. In the Command prompt field I type G 20 and then in the File mode I select my saved G code and then I turn my Shapeoko and trimmer on. Then in the console it shows - connected to Port 5 at 115200 band and Grbl0.0g. Now I press SEND and the trimmer moves approximately 1/16 " back and forth -on the same spot. It tells me that somewhere the settings are not correct in inches and millimeters.

I would appreciate any help in solving this problem.

SamPris
Posts: 27
Joined: Fri May 02, 2014 3:18 pm
Model of CNC Machine: Shark HD 2.0
Location: Eaton Rapids MI

Re: Router not mouving!

Post by SamPris »

Try doing a search here and Shapeoko forums others have had similar issues milar. Below are a few links I found.

http://forum.vectric.com/viewtopic.php? ... 34#p149134
http://www.shapeoko.com/forum/viewtopic.php?f=6&t=4589

Good luck in your search

Post Reply