add a post processor to PhotoVCarve
add a post processor to PhotoVCarve
the post processor choices in PhotoVCarve so I copied it to the Program Files/PhotoVCarve/PostP directory and get the error shown when opening PhotoVCarve.
- IslaWW
- Vectric Wizard
- Posts: 1402
- Joined: Wed Nov 21, 2007 11:42 pm
- Model of CNC Machine: CNC Controller Upgrades
- Location: Bergland, MI, USA
Re: add a post processor to PhotoVCarve
Tom...
IF there is not a proper postP for your machine in PVC, you can remove the non supported lines from a working post by editing out the ones that return the error, save, then reopen PVC. Slow, but it works.
In your example, the complete arc section will need to be removed. PVC does not support Gcode arcs.
IF there is not a proper postP for your machine in PVC, you can remove the non supported lines from a working post by editing out the ones that return the error, save, then reopen PVC. Slow, but it works.
In your example, the complete arc section will need to be removed. PVC does not support Gcode arcs.
Gary Campbell
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com