picture
-
- Vectric Wizard
- Posts: 414
- Joined: Wed Apr 01, 2009 12:15 am
- Location: Dunnellon, Florida
picture
Hi Folks: Here is a scene I photo vcarved a la lithophane. The picture had been taken in the winter which helped me out a lot. The snow on the ice helped give a wind blown pond surface and the house was not obscured be tree limbs etc. So I ended up with a 3d picture about 15 inches wide and 13 inches high. The house was done as a separate litho superimposed into the picture at the correct spot. That way I was able to crop in to the house and get more details for painting. A little bit of paint using a summertime photo as a guide and a nice plaque for the front porch is done. Norm
- Leo
- Vectric Wizard
- Posts: 4091
- Joined: Sat Jul 14, 2007 3:02 am
- Model of CNC Machine: 1300 x 1300 x 254 Chinese Made
- Location: East Freetown, Ma.
- Contact:
Re: picture
Norm,
That is a GREAT job.
I like the way you constructed it.
The painting is also Great - lot to be learned about painting.
That is a GREAT job.
I like the way you constructed it.
The painting is also Great - lot to be learned about painting.
Imagine the Possibilities of a Creative mind, combined with the functionality of CNC
- bill565
- Vectric Craftsman
- Posts: 116
- Joined: Sat May 10, 2008 4:58 pm
- Model of CNC Machine: One of those "Practical"4x4s
- Location: Jafrey New Hampshire
- Contact:
Re: picture
Great Job and interesting way to use the litho. I don't know if I have the steady hand for the painting, but it does give ideas.
Thanks for sharing.
bill
Thanks for sharing.
bill
Save the Whales, Collect the Whole Set
http://www.bcnc-fab.com
http://www.bcnc-fab.com
-
- Vectric Craftsman
- Posts: 129
- Joined: Wed Mar 30, 2011 5:55 pm
- Model of CNC Machine: RF31, 4X8 Router both CNC
Re: picture
Looking Good Norm.
Ray
Ray