Aspire/photo carve Question

This forum is for general discussion about PhotoVCarve.
Post Reply
cncwind
Posts: 24
Joined: Mon May 05, 2014 4:40 pm
Model of CNC Machine: Probotix-Meteor
Location: Clear Lake Iowa

Aspire/photo carve Question

Post by cncwind »

Probably a silly question, but just want to make sure.

I am running Aspire 3.5 and I would like to start Photo carving, is Photo carve additional software?

I am assuming so, but just wanted to double check

User avatar
Adrian
Vectric Archimage
Posts: 14544
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: Aspire/photo carve Question

Post by Adrian »

Aspire can do Photo V Carving as well.

http://forum.vectric.com/viewtopic.php?f=28&t=8731

Make sure to read the posts after the first one as the technique is expanded and simplified as it goes on.

Post Reply