PVC cutting into dual acrylic

This forum is for general discussion about PhotoVCarve.
Post Reply
johanna2350
Posts: 1
Joined: Fri Feb 28, 2014 11:43 pm
Model of CNC Machine: Stinger II

PVC cutting into dual acrylic

Post by johanna2350 »

Hello,

I need some guidance. For the past several weeks, I have been trying to use PVC software to engrave a black and white photo into dual acrylic - white on surface and black underneath.

Here is my photo and my cutting parameters.....

5 x 5 is the size (inches)
XY origin in the middle
Z Zero on the top of the board

Romark
0.052 thickness
Top surface white
Bottom surface black


Engraving bit 1/8 60D 0.004
CMD 0.007
LS 40%
# of Lines 1346
DBL 0.005
angle 22
100% Contrast

I would appreciate any and all suggestion. Thank you Johanna Haack TheWoodGrainGallery
Attachments
Original Photo
Original Photo
Maltese 03272014.pvc
PVC rendering
(1.08 MiB) Downloaded 172 times

Post Reply