Photovcarve - GBRL Post Processor Problem

This forum is for general discussion about PhotoVCarve.
Post Reply
GSink
Posts: 2
Joined: Sat Aug 11, 2018 11:36 am
Model of CNC Machine: Mini Mill, C-Beam

Photovcarve - GBRL Post Processor Problem

Post by GSink »

Hi,
I just went to try an generate my first paths and found there was no post processor for Gbrl (mm) as there is for VCarve. I tried to copy the .pp file from Vacrve to PhotoVcarve as found online,
but there is an error returned for an unknow statement.. ANyone go thru this yet?
I am running a mini mill using a CNC Pro board and using straight Gbrl..
Thabks
G.,
Attachments
vcarve Problem.png

GSink
Posts: 2
Joined: Sat Aug 11, 2018 11:36 am
Model of CNC Machine: Mini Mill, C-Beam

Re: Photovcarve - GBRL Post Processor Problem

Post by GSink »

I tried commenting out the line and ran the resulting gcode and it ran well.. actually very well.. Surpised and pretty happy with the results from a very difficult pic..
Regards

Post Reply