wolfeman wrote:Hey Jim, after cutting out the square boards can tabs be put along the sides so they do not move. Is that something that can be done in Regular Vectric or would it have to be put into the Gadget, If someone had a cutter beg enough to cut out several parts at one time. I do not know how Vectric and Gadgets interact with each other. If tabs could be add through vectric during the Gabinet Gadget was done there there is no big deal. Long counter top but want to cut as one long piece then split where tabs are rather then a lot of small cut out pieces. Just a though. No big deal.
Okay, I think I understand, holding tabs are usually added as apart of the tool path process. In the create toolpath menu, check the box and you can edit the amount and placement.
FYI. I know everyone may not have a mill that can handle full size sheet goods. You can still use the cabinet gadget. Run the gadget and build the cabinet. Print out the drawing and the bill of materials for a cut list. It should save you some time.