Page 2 of 2
Re: Plate Easel - stand
Posted: Sat Nov 13, 2010 2:45 am
by esteeme1
Hi Tim,
Very nice! I think I can use that for my plaques and Cutlass racks.
Thank
Re: Plate Easel - stand
Posted: Fri Nov 19, 2010 12:23 am
by glenn
Hi Tim,
Wonderful stand, Thanks for sharing-
Looks like my wife will get a few chunks of pretty wood instead of coal in her stockings this Christmas!
You really give inspiration!
Glenn
Re: Plate Easel - stand
Posted: Sat Nov 20, 2010 11:33 pm
by jporter
Thanks a lot, Tim. This is very nice of you. I also saw and admired this little piece at Memphis. Really nice to meet you. joe
Re: Plate Easel - stand
Posted: Mon Jan 17, 2011 2:03 pm
by GripUs
Tim,
Most kind of you to share! Perhaps I will have time in my retirement to make one of your inlaid plates and a stand for it!
Thanks again,
Joe
Plate Easel - stand
Posted: Fri Jan 12, 2018 12:45 pm
by Bobtail Farm
Tim,
Thanks for the design. The design scales well for variety of sizes. Tweaked it to suit my needs.
1/2" Solid surface material, 1/8" end mill, and 1/2" 60 degree v-bit.
Brian.
Re: Plate Easel - stand
Posted: Sat Jan 13, 2018 9:24 pm
by Jane Ndungu
Beautiful Projects,thanks for the files.
Jane