Hi Tim,
Very nice! I think I can use that for my plaques and Cutlass racks.
Thank
Plate Easel - stand
- esteeme1
- Vectric Wizard
- Posts: 2132
- Joined: Tue Nov 02, 2010 3:26 pm
- Model of CNC Machine: Cobra 404 ATC; ROMAX WD-1; Shark
- Location: Chesapeake VA
- Contact:
Re: Plate Easel - stand
Jim Darlas
"Can Do!"
http://www.esteemedwoodcrafts.com/
http://www.esteemedplaques.com/
"Can Do!"
http://www.esteemedwoodcrafts.com/
http://www.esteemedplaques.com/
- glenn
- Vectric Wizard
- Posts: 582
- Joined: Wed Jul 02, 2008 11:23 pm
- Model of CNC Machine: home brew 40x20
- Location: McArthur, Ohio U.S.A.
Re: Plate Easel - stand
Hi Tim,
Wonderful stand, Thanks for sharing-
Looks like my wife will get a few chunks of pretty wood instead of coal in her stockings this Christmas!
You really give inspiration!
Glenn
Wonderful stand, Thanks for sharing-
Looks like my wife will get a few chunks of pretty wood instead of coal in her stockings this Christmas!
You really give inspiration!
Glenn
Re: Plate Easel - stand
Thanks a lot, Tim. This is very nice of you. I also saw and admired this little piece at Memphis. Really nice to meet you. joe
- GripUs
- Vectric Wizard
- Posts: 806
- Joined: Thu Jan 18, 2007 2:07 pm
- Location: San Angelo, Texas
- Contact:
Re: Plate Easel - stand
Tim,
Most kind of you to share! Perhaps I will have time in my retirement to make one of your inlaid plates and a stand for it!
Thanks again,
Joe
Most kind of you to share! Perhaps I will have time in my retirement to make one of your inlaid plates and a stand for it!
Thanks again,
Joe
Ham and eggs - Inconvenient for the chicken. A total commitment for the pig.
http://www.gripus.com/
http://www.gripus.com/
-
- Vectric Craftsman
- Posts: 289
- Joined: Mon Dec 01, 2014 3:53 pm
- Model of CNC Machine: Homemade
Plate Easel - stand
Tim,
Thanks for the design. The design scales well for variety of sizes. Tweaked it to suit my needs.
1/2" Solid surface material, 1/8" end mill, and 1/2" 60 degree v-bit.
Brian.
Thanks for the design. The design scales well for variety of sizes. Tweaked it to suit my needs.
1/2" Solid surface material, 1/8" end mill, and 1/2" 60 degree v-bit.
Brian.
-
- Vectric Craftsman
- Posts: 201
- Joined: Fri Oct 31, 2014 8:14 am
- Model of CNC Machine: TS1325
Re: Plate Easel - stand
Beautiful Projects,thanks for the files.
Jane
Jane