About 0.4" deep and about 4x5 to 7x9
Rough 10 minutes with a 1/4" end mill.
Finish pass using a 1/16 tapered ballnose with a 7% stepover at 180IPM and 18K RPM for 57 minutes per panel.
Holy Week Test Cuts in 3/4 Poplar
- Rcnewcomb
- Vectric Archimage
- Posts: 5887
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Holy Week Test Cuts in 3/4 Poplar
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
Re: Holy Week Test Cuts in 3/4 Poplar
Very nice! But how do you plan to use them? On furniture or something? Just curious.
- Rcnewcomb
- Vectric Archimage
- Posts: 5887
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Holy Week Test Cuts in 3/4 Poplar
In Florence,Italy I saw church doors with sets of carvings. Ghiberti created a set I admire. I thought it might be interesting to make a door for my local church. I’m not sure how soon this would happen, but these were some test cuts.
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
- Rcnewcomb
- Vectric Archimage
- Posts: 5887
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Holy Week Test Cuts in 3/4 Poplar
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
- TReischl
- Vectric Wizard
- Posts: 4596
- Joined: Thu Jan 18, 2007 6:04 pm
- Model of CNC Machine: 8020 48X36X7 RP 2022 UCCNC Screenset
- Location: Leland NC
Re: Holy Week Test Cuts in 3/4 Poplar
Ahhh, to be able to carve like that!!! ::::sigh:::::
Thanks for posting those pics Randy.
Thanks for posting those pics Randy.
"If you see a good fight, get in it." Dr. Vernon Johns
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: Holy Week Test Cuts in 3/4 Poplar
I didn't know that had CNC machine way back then!!!
John
Maker of Chips
Maker of Chips
Re: Holy Week Test Cuts in 3/4 Poplar
highpockets wrote:I didn't know that had CNC machine way back then!!!
a [C]ouple of [N]uns w/ [C]hisels? lol.
But those carvings are really nice. Are these thin wood pieces carved, then glued to the door?