My version of Michael's Table Trellis. I too went 'Au Naturel' with just a couple coats of shellac.
Oops, looks like I neglected to sand one of the tabs completely
Also, anyone know of an H20 that will work with plastic? Flowers look a little droopy
Table Trellis
- Bob Jr
- Vectric Wizard
- Posts: 463
- Joined: Thu Aug 13, 2009 2:13 am
- Model of CNC Machine: Axiom, Shark
Re: Table Trellis
Nice job on the Table Trellis.
Remember, Any mistake or tab is a "design element".
Bob
Remember, Any mistake or tab is a "design element".
Bob
"Be accurate."
W. Tell
W. Tell
- mtylerfl
- Vectric Archimage
- Posts: 5896
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Table Trellis
Great job, Ron!!
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC