mtylerfl wrote:Beautiful work, Dwayne!
dwilli9013 wrote:Well here is my take on Beki's free project Heart shaped box.
My wife and I recently lost one of our fur babies to cancer. So I had bought the bracelet for my wife for Valentines. Then this free project came out. It was perfect for my needs.
Thank you so much for this one.
Top & Bottom of the box is Redwood.
The center section is Cherry.
All cut with 1/4 BN endmill. 60 degree V-Bit for text and chamfer.
Finish is simply 4 coats of rattle can poly with a light sand between coats.
It was very well received and is much loved by my wife.
Thanks again for the free project and all that you all do at Vectric & Design & Make for our community.
Users browsing this forum: Roly and 6 guests