Page 1 of 1
Just Made Christmas Presents
Posted: Thu Dec 20, 2018 3:02 pm
by johntech
I just finished up this for one of my sisters for Christmas. Two more to get cut this week!
On a side note, I can add graphics to the book graphics but is it possible to add a 3d photo to one side of the book?
Thank you.
John Frankforther
Re: Just Made Christmas Presents
Posted: Thu Dec 20, 2018 8:21 pm
by Royrufus
Very nice. I'm going to try to duplicate this next time I need a wedding give.
Re: Just Made Christmas Presents
Posted: Sat Dec 22, 2018 10:09 am
by scottp55
Congrats John:)
Wow, you've really got a lot to do, Fingers crossed for no glitches for you!!
Break a leg, and well done!
scott
Re: Just Made Christmas Presents
Posted: Sat Dec 22, 2018 12:52 pm
by mezalick
If the book is from Vectric's clip art collection or Design and Make,,,,then you can add 1 additional 3rd party model..
Michael
Re: Just Made Christmas Presents
Posted: Sat Dec 22, 2018 11:12 pm
by sharkcutup
Very Nice! What is the font name that was used for that?
Sharkcutup
Re: Just Made Christmas Presents
Posted: Mon Dec 24, 2018 12:27 am
by johntech
sharkcutup wrote:Very Nice! What is the font name that was used for that?
Sharkcutup
It was the Lucida Calligraphy