Page 1 of 1

Zebra Box

Posted: Tue Oct 16, 2018 11:33 pm
by wb9tpg
This cherry box is 4" in diameter. The top is V-carved with the patterns. Finish is Shellac and Lacquer.

This one is for my granddaughter Zoey
IMG_1600.jpg

Re: Zebra Box

Posted: Tue Oct 16, 2018 11:58 pm
by mtylerfl
Gary,

Very nice work! What feedrate and rpm did you use for the zebra box v-carve?

Re: Zebra Box

Posted: Wed Oct 17, 2018 2:02 am
by wb9tpg
18,000 RPM and 10.1 IPM feed rate. I adjust the RPM a little by how it sounds cutting

Re: Zebra Box

Posted: Wed Oct 17, 2018 2:54 am
by mtylerfl
Thank you for the additional info!