Did this over the weekend and into yesterday. Took 24 1/2 hrs , seems like a lot but there is a lot of detail and the finish toolpath was done with a 1/32 tapered ballnose. Picture sure doesn't do it justice . Any suggestions for a good finish ?? Thanks for looking. Just off machine as is.
Dave
STL file
-
- Vectric Wizard
- Posts: 493
- Joined: Sat Jun 11, 2011 3:27 pm
- Model of CNC Machine: Probotix Meteor 25 x 50
- Location: Jefferson City, Mo.
STL file
Dave
- Rcnewcomb
- Vectric Archimage
- Posts: 5887
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: STL file
I'd suggest doing a very light glaze with something like Minwax Honey Maple glaze, followed by a satin lacquer.suggestions for a good finish?
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
-
- Vectric Wizard
- Posts: 493
- Joined: Sat Jun 11, 2011 3:27 pm
- Model of CNC Machine: Probotix Meteor 25 x 50
- Location: Jefferson City, Mo.
Re: STL file
Dave
-
- Posts: 5
- Joined: Thu Jun 14, 2018 9:19 am
- Model of CNC Machine: WorkBee
Re: STL file
Very nice work Dave, do you have a picture with the frame fully complete? Would be nice too see.
Darren
Darren