This cherry box is 4" in diameter. The top is V-carved with the patterns. Finish is Shellac and Lacquer.
This one is for my granddaughter Zoey
Zebra Box
- mtylerfl
- Vectric Archimage
- Posts: 5865
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Zebra Box
Gary,
Very nice work! What feedrate and rpm did you use for the zebra box v-carve?
Very nice work! What feedrate and rpm did you use for the zebra box v-carve?
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
-
- Vectric Wizard
- Posts: 456
- Joined: Tue Sep 04, 2018 2:49 pm
- Model of CNC Machine: Shapeoko 3 XL
Re: Zebra Box
18,000 RPM and 10.1 IPM feed rate. I adjust the RPM a little by how it sounds cutting
Gary Mitchell
Kentucky, USA
Kentucky, USA
- mtylerfl
- Vectric Archimage
- Posts: 5865
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Zebra Box
Thank you for the additional info!
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC