I have set myself up to a new many piece project. I plan to do all 32 counties of Ireland.
1 = Corian
2 = 6.875
3 = 11.875
4 = 1/2 About 2 hours per. Using the quick engrave. .005 deep I am using a V bit with a .060 flat
cross hatch set at .060 line width.
This was a test cut and I forgot the number one RULE measure twice and cut once.
So County Cavan will need to be redone. I do not know how deep the texture in corian
is. I may try to surface this piece and use it again.
You may see some spots that look like missed parts. those are a reflection from water I just rinsed it
Don
New long time project
- Makingtoothpicks
- Vectric Wizard
- Posts: 520
- Joined: Tue Jul 23, 2013 8:46 pm
- Model of CNC Machine: Cncrouterparts CPR2448
- Location: Burien, Wa
- Contact:
- Makingtoothpicks
- Vectric Wizard
- Posts: 520
- Joined: Tue Jul 23, 2013 8:46 pm
- Model of CNC Machine: Cncrouterparts CPR2448
- Location: Burien, Wa
- Contact:
Re: New long time project
The pattern of the Corian, goes all the way through. So resurfacing the face would be fine.
- Makingtoothpicks
- Vectric Wizard
- Posts: 520
- Joined: Tue Jul 23, 2013 8:46 pm
- Model of CNC Machine: Cncrouterparts CPR2448
- Location: Burien, Wa
- Contact:
Re: New long time project
Thank you I will give it a try.
Don
Don