House Warming Cutting Board
-
- Vectric Apprentice
- Posts: 70
- Joined: Mon Feb 06, 2017 7:07 pm
- Model of CNC Machine: Laguna IQ
- Location: Ladera Ranch CA
House Warming Cutting Board
Here is a house warming present for the In-Laws. They are moving from Michigan to Nevada. I put rubber feet on the base so it won't slide around if they decide to use it. Since it is two sided I couldn't put feet on the actual cutting board so I built the base. The board sits about 1/2" into the base. I also added handles to it after these pictures were taken.
-
- Vectric Wizard
- Posts: 520
- Joined: Tue Jul 21, 2009 8:22 pm
- Model of CNC Machine: ShopBot Buddy Standard
- Location: Marietta, GA.
Re: House Warming Cutting Board
Very nice, shows a lot of work and thought...joe
- mtylerfl
- Vectric Archimage
- Posts: 5896
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: House Warming Cutting Board
What a great idea, Ken! Wonderful gifts!
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
- scottp55
- Vectric Wizard
- Posts: 4717
- Joined: Thu May 09, 2013 11:30 am
- Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP11.5
- Location: Kennebunkport, Maine, US
Re: House Warming Cutting Board
VERY thoughtful and well executed Ken!
What were the woods used?
What flat depth did you decide on for the female pocket?
NICE present!!
scott
What were the woods used?
What flat depth did you decide on for the female pocket?
NICE present!!
scott
I've learned my lesson well. You can't please everyone,so you have to please yourself
R.N.
R.N.
-
- Vectric Apprentice
- Posts: 70
- Joined: Mon Feb 06, 2017 7:07 pm
- Model of CNC Machine: Laguna IQ
- Location: Ladera Ranch CA
Re: House Warming Cutting Board
The wood is Wenge and Mahogany. as for the female it was 1/2 90 degree v bit at .2 dept and the male at .1 and .1
- scottp55
- Vectric Wizard
- Posts: 4717
- Joined: Thu May 09, 2013 11:30 am
- Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP11.5
- Location: Kennebunkport, Maine, US
Re: House Warming Cutting Board
Thanks Ken!
Yeah, that depth combo works very well
I hope they treasure it.
scott
Yeah, that depth combo works very well
I hope they treasure it.
scott
I've learned my lesson well. You can't please everyone,so you have to please yourself
R.N.
R.N.