Vectric Customer

Jewelry box created with Vcarve Pro and an Axiom Basic 4. Cherry wood stained with Antique Cherry Stain. 60 degree Vbit

Very Nice. I like it a lot. Did you mill the trim?

Absolutely gorgeous! Great job!

Beautiful work!!!

Thanks for sharing....

mtylerfl wrote:Absolutely gorgeous! Great job!

Thank you. Your Paradise Box was my inspiration. I learned a lot by doing yours.

gkas wrote:Very Nice. I like it a lot. Did you mill the trim?

Thank you. The trim was done on my router table. The top and sides were all carved and cut out on my Axiom.

Very nice. I am about to make a jewelry box. You have given me some ideas.
I can only hope mine turns out half as good as yours.

Don

Very Nice. Thanks for sharing.

What an outstanding project and design!

Did you develop the design in Vcarve Pro?

Dan

Thank you for the kind remarks. The carving designs were found in a chip carving design and pattern book by Wayne Barton. I then developed it to suit my project using Vcarve and Illustrator. The Paradise Box, which was a project of the month by Michael Tyler, was my inspiration to try and develop something on my own . I do a lot of box work in my woodworking. My CNC along with Vectric has enhanced my work tremendously. The Vectric Vcarve software makes the process so easy and fun to do.

That's one beautiful piece!

Greg

Now that’s a nice jewelry box.