Vectric Customer

Hey Everyone,

I'm new here and just picked up the HD Shark a few months ago.

I'm working on making boxes and would love some input and or help with doing an inlay and how you control your work space to make sure that every piece you put in is correct every time.

The project I am working on is a box for our coin company a 5 x 5.5 inch cherry wood single line vector but would like to figure out how to do an inlay with fine detail.. If its even possible.

Is there an equation to all of this?

Anyway,

Any help would be appreciated.

Cheers

-Trenton

https://www.facebook.com/photo.php?fbid ... heater[url][/url]

I'd recommend stopping and watching the tutorials on the Vectric website under support. It will reduce frustrations in the long run.

Here's a link to inlay thread http://forum.vectric.com/viewtopic.php?f=3&t=564

highpockets wrote:I'd recommend stopping and watching the tutorials on the Vectric website under support. It will reduce frustrations in the long run.

Here's a link to inlay thread http://forum.vectric.com/viewtopic.php?f=3&t=564

Thank you for this!!! That gives me a lot of the information I was looking for.

Cheers

-Trenton