Vectric Customer

95% credit for this project goes to Wood Magazine 2010 July issue. All I did was take their pdf files and changed them in crv files. Then I added some oak & maple and for the finish-it was given to my three small grandchildren!

That came out great. I'm sure the grandkids love 'em!

I made one of these for a very special little girl, last year.
The plans are for a boy, so I did some extra work and made a girl.
Sounds like you went through the same process as I did.

Very nice!! Are you a ham operator by chance? I am N5PU.

I am W3LMR Always good to meet a fellow Ham Operator & fellow woodworker!

Not to run off on a tangent but N5IWA here.

73

This could go on

VK3AWA

I found the plans for this clock here https://www.skiltools.com/How-To/Docume ... ClockR.pdf.
It was postred by Skil tools, I'd have to assume that they had permission from Wood Magazine

Here are my versions of the Dancing Clock. They are designed to be hanging wall clocks to avoid any child play accidents!
Sharkcutup

The originating plans are from Meisel Hardware Specialties, http://meiselwoodhobby.com/Products/Vie ... &Path=2941 and are a bit more money that Wood Magazine sells them for....$15.00. They, Meisel, sell the clock kit and face...for a bit more of course. Cute never the less and youse guys did a great job. On my bucket list now.

George
WA0FSE

What beautiful work for the Children, Gentlemen!


Just sharing my Canadian presence with the crowd! Very talented HAM's on this forum.
I`m pleased to welcome my existence to the Vectric community as a Newbie!

Hope to be able to share some of my ideas once I am able to purchase my CNC later this Spring (I`ve been waiting since I quit smoking back in October 2015... but then again other commitments...).

73 de
VE5MDH
Michael