First LED Engravings

Post by **PDXHawkeye** » Sun Jul 24, 2016 4:49 pm

I did my first LED engravings on the CNC.

Post by **highpockets** » Sun Jul 24, 2016 5:37 pm

Nice clean look.

How did you do it?

Post by **Bonch** » Mon Jul 25, 2016 12:59 am

Great job. I need to learn this technique. Those are beautiful and stand out so well.

Post by **PDXHawkeye** » Mon Jul 25, 2016 12:46 pm

Thanks, I used a diamond spring loaded engraving bit. I had the speed turned to 50 IPM to help with the detail.

Post by **PDXHawkeye** » Tue Jul 26, 2016 2:10 am

How do I get rid of the line that I blown up on the wings? This area is where it will stop and go to another place and start and finish at those spots areas.

Post by **bolingerbe** » Tue Jul 26, 2016 2:16 am

Great Job

Post by **highpockets** » Tue Jul 26, 2016 2:50 am

PDXHawkeye wrote:How do I get rid of the line that I blown up on the wings? This area is where it will stop and go to another place and start and finish at those spots areas.

Check your Z clearance under Material Setup, it may not be high enough to accommodate the spring in the engraver.

Vectric Customer

First LED Engravings

First LED Engravings

Re: First LED Engravings

Re: First LED Engravings

Re: First LED Engravings

Re: First LED Engravings

Re: First LED Engravings

Re: First LED Engravings