Gatling Derringer

An area to upload images of pieces cut using VCarve Pro

Gatling Derringer

Postby Bob Jr » Thu Jan 28, 2016 4:24 pm

Based upon the design published in Gizmos and Gadgets, I built a full sized version, one of our group members made a smaller one, so I made a smaller one yet.
DCP02921.JPG
Since "Bigger Is Better" seems to be common, it's fun to go the other direction.
Bob
hammer...nails...stuff
User avatar
Bob Jr
Vectric Wizard
 
Posts: 313
Joined: Thu Aug 13, 2009 2:13 am
Model of CNC Machine: Axiom, Shark

Re: Gatling Derringer

Postby Makingtoothpicks » Thu Jan 28, 2016 9:37 pm

I tried to find the plans for the Gatling but cannot. Where did you get them

Thank You
Don
User avatar
Makingtoothpicks
Vectric Apprentice
 
Posts: 489
Joined: Tue Jul 23, 2013 8:46 pm
Location: Burien, Wa
Model of CNC Machine: Cncrouterparts CPR2448

Re: Gatling Derringer

Postby FixitMike » Fri Jan 29, 2016 1:08 am

There is a Gatling plan in the Scrollsaw Woodworking magazine's Gizmos and Gadgets special issue. It also has the Mad Scientist Lightswitch.
Good judgement comes from experience.
Experience comes from bad judgement.
User avatar
FixitMike
Vectric Wizard
 
Posts: 1564
Joined: Sun Apr 17, 2011 5:21 am
Location: Renton, WA USA
Model of CNC Machine: Shark Pro Plus (extensively modified)

Re: Gatling Derringer

Postby Bob Jr » Fri Jan 29, 2016 2:33 am

I could not locate one on their website, but I did find them here: http://www.amazon.com/Scrollsaw-Woodwor ... B017O45VFS
Bob
hammer...nails...stuff
User avatar
Bob Jr
Vectric Wizard
 
Posts: 313
Joined: Thu Aug 13, 2009 2:13 am
Model of CNC Machine: Axiom, Shark


Return to VCarve - Gallery

Who is online

Users browsing this forum: No registered users and 12 guests