First/last project posted from VCarve
-
- Posts: 46
- Joined: Wed Aug 12, 2015 10:01 pm
- Model of CNC Machine: ShopBot Desktop
First/last project posted from VCarve
Plaque made in VCarve for SNCO induction, pretty much at cost (since I'm not much of a craftsman... Specially after looking at the fantastic work posted on this forum).
But it was fun working on it and learning.
-
- Posts: 46
- Joined: Wed Aug 12, 2015 10:01 pm
- Model of CNC Machine: ShopBot Desktop
Re: First/last project posted from VCarve
Sorry should explain, first project I've posted here, but last on this gallery as I will be using Aspire for all my newer stuff... cept maybe one more;
- dhellew2
- Vectric Wizard
- Posts: 1326
- Joined: Thu May 22, 2008 10:14 pm
- Model of CNC Machine: Legacy Artisan 72 and AVID CNC Rotary
- Location: Royal City Washington
Re: First/last project posted from VCarve
Looks good to me. Just remember... there are more folks that cannot make anything, therefore, anything you make is better than theirs. Dale
You will get old if you live long enough!
Young = time, no money
Old = money, no time
Dale
Young = time, no money
Old = money, no time
Dale
- scottp55
- Vectric Wizard
- Posts: 4717
- Joined: Thu May 09, 2013 11:30 am
- Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP11.5
- Location: Kennebunkport, Maine, US
Re: First/last project posted from VCarve
Lookin' good!
scott
scott
I've learned my lesson well. You can't please everyone,so you have to please yourself
R.N.
R.N.