birthday present for my wife

[Bob Jr]

I saw this nifty cutting board made by Scott Lewis, and featured by Fine Woodworking, http://www.finewoodworking.com/how-to/v ... -ever.aspx
So I copied it as a birthday present for my wife. It is a nice combination of cnc and conventional woodworking.
It's one of those projects that looks kind of simple until you start looking at the variables, and procedures.

Bob

[scottp55]

I always liked those:)
GOOD Work

[vgraves]

Very impressive. It's obvious it would take quite an effort to do manually, and I'm sure it wasn't trivial even with CNC!

[mtylerfl]

Wow! That is really classy and nice!

[Bob Jr]

Thanks,
It was fun watching Scott's video, then appreciating, and copying his technique. The cnc saved some time and added accuracy when cutting out the curvy profiles, but there was still a lot of gluing, then cutting into the finished work for the next band. And, making sure everything lined up properly while gluing.
Fun stuff.
Bob

[Bob Jr]

...This seemed like a good picture to add. You can never have too many clamps:

[roy_okc]

Bob,

Very nice. Too nice to cut on!

Roy